Company logo
Installation and Operating InstructionsSearchContentsHome
 
Tractor-ECU applicationConfiguring the parameters for a vehicle profileEntering the position of the GPS ReceiverFor machines fitted with an ISOBUS job computer
 
 
For machines fitted with an ISOBUS job computer
 
On the following illustration distances are marked, which must be measured for each different machine.
 
 
 GPS-Antennenoffset_ISO Maschinen_Selbstfahrer und Schlepper
GPS receiver for ISOBUS machines
Attachment point for mounted or trailed implements
GPS receiver
Mounted or trailed implements
Self-propelled machines
y
Distance between the longitudinal axis and the GPS receiver
for Offset Y
x
Distance for Offset X
 
 
 
Procedure
 
 
 
To determine the distances for tractors with an ISOBUS-job computer:
þ
The jobcomputer of the farm equipment in use is connected to the terminal
þ
In the jobcomputer the geometry of the farm equipment is configured.
1.
Measure the distance between the attachment point of the attached or trailed implement and the GPS receiver.
2.
Input the measured distance as parameter "Offset X".
3.
Measure the distance between the longitudinal axis of the machine and the GPS receiver.
4.
Input the measured distance as parameter "Offset Y".
 
 
 
Procedure
 
 
 
To determine the distances for self-propelled machines with an ISOBUS job computer:
þ
The jobcomputer of the farm equipment in use is connected to the terminal
þ
In the jobcomputer the geometry of the farm equipment is configured.
1.
Input 0 inch as parameter "Offset X".
2.
Measure the distance between the longitudinal axis of the machine and the GPS receiver.
3.
Input the measured distance as parameter "Offset Y".