Configuring the GPS receiver
The internal software for each GPS receiver must be configured. You can configure the following GPS receivers offered by Müller-Elektronik via the terminal:
- ▪
- A100, A101
- ▪
- AG-STAR, SMART-6L
All other GPS receivers must be configured in accordance with their manufacturer's instructions.
Procedure
To configure the parameters:
- þ
- A GPS receiver is connected to socket C of the terminal.
- þ
- The GPS receiver is connected directly to the terminal. Additional devices such as ME LightBar or tilt module may not be connected in between.
- þ
- The appropriate driver is activated.
- þ
- The driver of the ME Lightbar "LightBar" is deactivated. Otherwise the DGPS receiver cannot be configured.
- ⇨
- A selection list will appear.
- ⇨
- For some parameters is it necessary to restart the terminal. In these cases, the following notification will appear:
"Restart the terminal."
- ⇨
- You have configured the DGPS receiver.
- 5.
- Reconnect all of the additional devices that you had disconnected for the configuration.
Further information