Connecting the terminal to the ISOBUS
When it is connected to the ISOBUS, the terminal is supplied with voltage and communication is possible with other ISOBUS components.
You will need a different connection cable for this, depending on the model of your tractor.
- ▪
- In tractors that have been retroactively upgraded with an ISOBUS basic vehicle harness manufactured by Müller-Elektronik, use connector cable A from the ISOBUS basic vehicle harness.
- ▪
- In tractors that are equipped as standard with ISOBUS and that have an ISOBUS in-cab connector, you will need the following connector cable:
Connector cable D-Sub <-> CPC Item no. 30322541
When there is more than one terminal in the tractor cab, you may need to change certain settings in order to enable two-way communication. Find out more: Using two terminals
Procedure
- 1.
- Connect the 9-pin connector A of the basic vehicle harness to the CAN port of the terminal.
- 2.
- Tighten the safety screws on the connector.