Configuring the AG-200
Procedure
- þ
- The GPS receiver is connected to the terminal.
- þ
- The “AG-200, NAV-900” driver is activated.
- Open the “Service” application.- 2.
- Tap “GPS”.
- ⇨
- The “AG-200” screen appears.
- ⇨
- The terminal reads the current configuration of the GPS receiver.
- 3.
- Tap “Settings“.
- ⇨
- You can now see all of the configurable parameters.
- 4.
- Configure the parameters. The parameters can be found on the following pages. The parameters that you need to configure depend on the respective correction source and the respective activation. Only those parameters that need to be configured are shown.
- Save the configuration.- 6.
- Confirm.
Further information