Anbau- und Bedienungsanleitung - GSM modem for SMART-6L

Installation and Operating Instructions

Table of contents

GSM modem for SMART-6L

If you are using the DGPS/GLONASS SMART-6L receiver with a GSM modem, you can adjust the existing configuration.

Procedure

1.: - Open the “Service” application.

2.: Tap “GPS”.

3.: The “Settings” screen appears.

4.: - Open the configuration menu.

5.: Configure the parameters. The explanations for the individual parameters can be found in the table at the end of this section.

6.: - Save the changes.

⇨: The following message appears: “Should the data be transmitted to the modem?”

7.: “Yes” - to confirm.

⇨: The data is being transmitted to the modem. This will take approx. 30 seconds.

Parameter	Meaning	Possible entries
APN	Connection to the provider.	Provider URL or IP address.
User	Name for the Internet access. The name is the same for all users of a provider.	Name that was given by the provider. Some providers do not require entering a name.
Password	Password for the Internet access. The password is the same for all users of a provider.	Password that was given by the provider. Some providers do not require entering a password.
URL/IP	Connection to the correction data server.	Correction data server URL or IP address.
Port	Port at the correction data server.	Port number
NTRIP user	Name from the correction service to identify the customer account.	Letters and numbers. Pay attention to the use of upper and lower case letters.
NTRIP password	Password for the identification name.	Letters and numbers. Pay attention to the use of upper and lower case letters.
Mountpoint	Manual entry of a correction data source available only with GPRS connections.	Name of the correction data source / data stream.