Company logo
Installation and Operating InstructionsSearchTable of contentsHome
 
Configuring the job computerSelecting and configuring the speed sensorConfiguring the reverse driving sensor
 
 
Configuring the reverse driving sensor
 
 
Signal sources
 
The following signal sources are possible:
▪
“None” - The job computer should not expect a reverse driving signal. Even if a reverse driving signal is transmitted through the ISOBUS, the job computer will ignore the signal.
▪
“ISOBUS” - The reverse driving signal is sent by the tractor or a different job computer through the ISOBUS.
▪
“Sensor” - A reverse driving sensor is connected to the junction box or cable harness of the job computer.
 
 
 
Procedure
 
 
 
To select the reverse signal source:
1.
Switch to the “SPEED” screen:
 FS_JR3_Einstellungn-Menü >  FS_JR3_Geschwindigkeit-Einstellungen.
2.
Select the box below the “Reverse drive sensor” parameter.
⇨
The available signal sources appear. See the description at the beginning of this section.
3.
Select the signal source.
4.
Restart the job computer.