Configuring the job computer
Configuring the sides and sectionsConfiguring the number of sides and sections
Configuring the sides and sectionsConfiguring the number of sides and sectionsConfiguring the number of sides and sections
You must enter the number of sides that are assigned to a section.
In doing so, please note that a section does not necessarily refer to a physical section, but rather can also refer to a group of several sides/spraying areas.
Procedure
> 
.- ⇨
- The “Boom” screen appears.
- ⇨
- Here, you can see the set working width, the number of sections, and the number of sides. The values cannot be changed here.
- Press.- ⇨
- The “Total sides” screen appears.
- 3.
- Enter the number of sides for each section.
- ⇨
- With each change, the number of nozzles changes on the “BOOM” screen.
- Press and hold.- ⇨
- The “BOOM” screen appears.
- 5.
- Select the row spacing that you will be using during operation. You can select among 5 pre-configured row spacings.
- 6.
- Select whether the implement works the first side on the inside or outside.
- 7.
- Restart the job computer.