Instructions for safe installation
To prevent damage to the system components, consider the following during installation:
- ▪
- Install the job computer where it is protected from dirt. You therefore avoid unintentional cleaning of the job computer by the implement operator using a high-pressure cleaner.
- ▪
- In the installed position, the connectors and the pressure compensation membrane must be facing to the side.
- ▪
- Fasten the job computer with four fixing bolts and a flat washer (lock washers can cause cracks in the plastic on the long term) on a conducting spot on the implement chassis. In case of improper installation, the ESD discharges can cause malfunctions.
- ▪
- All of the sockets and connectors that are not used must be protected from dust and water using suitable dummy connectors.
- ▪
- All of the connectors must be tightly sealed. This makes them waterproof.
- ▪
- Do not use the system if some of its parts are damaged. Damaged parts can cause malfunctions and lead to injuries. Replace damaged components or repair them if possible.
- ▪
- Only use original components.