SPRAYER-Controller MAXI und MIDI 3.0 - Configuring the Raven direct injection

Table of contents

Configuring the Raven direct injection

If your sprayer is equipped with a direct injection manufactured by Raven, you have to configure it before using it for the first time.

Procedure

1.: Switch to the “INJECTION” screen:
> > >

2.: Activate the units that you want to use.

3.: - Switch to the calibration and diagnostics screen.

4.: Assign the individual units to each “ECU number”.

⇨: You have configured the Raven direct injection.

⇨: Depending on the status, the following icons can appear:

Status of the Raven direct injection

Display on the calibration screen	Display on the work screen	Meaning
		The job computer did not recognise the injection unit on the ISOBUS.
		The job computer recognised the injection unit on the ISOBUS, but is not receiving any messages from this unit.
		The job computer recognised the injection unit on the ISOBUS, and is also receiving messages from this unit. There is a connection between the job computer and the injection unit. But the injection unit is currently not ready.
		The job computer recognised the injection unit on the ISOBUS, and is also receiving messages from this unit. There is a connection between the job computer and the injection unit. The injection unit is ready, but the pump is switched off.
		The job computer recognised the injection unit on the ISOBUS, and is also receiving messages from this unit. There is a connection between the job computer and the injection unit. The injection unit is ready and the pump is switched on.