SPRAYER-Controller MAXI und MIDI 3.0 - Changing the display of areas on the terminal

Changing the display of areas on the terminal

You can make different settings to change the display of the areas on the terminal, e.g. for the TRACK-Leader application.

Procedure

2.: Configure the “Zero target rate areas” parameter. The following configuration options are available to you:

Sections off	Applied on the map	Function
deactivated	---	The sections are not closed when the application rate is 0 l/ha. Everything is recorded in the process.
activated	deactivated	The sections are closed when the application rate is 0 l/ha. Only the applied areas are recorded.
activated	activated	The sections are closed when the application rate is 0 l/ha. Both the applied areas and areas where nothing was applied will be recorded. This is the standard setting when using SECTION-Control.