SLURRY-Controller MIDI 3.0 - Calibrating the speed sensor with the 100m method

Calibrating the speed sensor with the 100m method

When calibrating the speed sensor with the 100m method, you determine the number of impulses received by the speed sensor in a distance of 100m. When you know the amount of impulses, the job computer can calculate the current speed.

After the first calibration, you can manually enter the number of impulses as the value of the “Wheel Impulses” parameter.

Procedure

1.: Drive the slurry tanker onto the field.

2.: Mark the tyre position on the ground. You can use a stone for instance.

3.: Measure a straight route of 100 m and mark the end.

4.: On the work screen, press:
> ( ) >

⇨: The “SPEED” screen appears.

5.: In the “Speed Source” parameter, select the value “Sensor”.

6.: In the “Detect Driving Direct.” parameter, select the value “Sensor”.

7.: - Call up the “CALIBRATION” screen.

8.: - Start the calibration.

9.: Drive the marked distance.

⇨: While driving, the counted impulses are shown in the “Counted Impulses” field.

10.: - Press when you have reached your destination.

⇨: Calibration will be finished.