Inserting the cable core into a terminal
Each terminal consists of two openings:
- ▪
- The upper opening of the terminal opens the lower opening.
- ▪
- The bottom opening of the terminal serves to insert and clamp one cable core.
Procedure
- þ
- You have prepared a small flat screwdriver that fits the upper opening of the terminal. You only need this screwdriver if there are no wire end sleeves on the cable cores.
- þ
- You have cut the cable to the proper length and have exposed the cable cores according to the instructions, or you have a finished cable from Müller Elektronik.
- þ
- The tractor engine is switched off.
- þ
- The junction box is not powered.
- þ
- There is no voltage on the components to be connected.
- 1.
- Find the proper connectors for the cable cores to be connected.
To do so, use the information on the lid of the junction box, on the relay circuit board and in the pin-out diagram.
- 2.
- Insert the cable core into the opening in the lower part of the terminal. If you are not using wire end sleeves, you first have to use the screwdriver.
- ⇨
- The cable core will be held by the terminal.
- ⇨
- You have clamped the cable core.