Bedienungsanleitung - Assigning target rates

Operating Instructions

Table of contents

Assigning target rates

Procedure

Assigning target rates

1.: Tap “Target rates”.

⇨: A list of target rates and prescription maps appears.

⇨: In the list, you now see the identifications of the prescription maps stored in the field data.

⇨: Target rates that have not yet been assigned to a metering unit are marked with the following icon:

2.: You now have two options:

3.: Option a: If the machine only spreads/applies one product, exit this screen with . In this case, the prescription map will not be assigned to a metering unit. All metering units then automatically use the same prescription map. The configuration is now complete.

4.: Option b: If the machine spreads/applies different products and the task therefore contains multiple prescription maps, you must assign them to the metering units. Proceed with the following steps.

5.: Tap the top line.

⇨: A form for entering the target rate appears. The lines “Quantity”, “Unit” and “Product” contain values from the prescription map.

6.: Tap “Implement element”.

7.: Select the metering unit that should work with the prescription map.

8.: - Exit the form.

⇨: You have assigned a prescription map to a metering unit.

9.: Repeat the procedure for all prescription maps in the list.

10.: - Exit the form.

⇨: You have started a task with a prescription map.

⇨: When you now drive to the field and activate the machine, the target rate matching the GPS position will be transmitted to the ISOBUS job computer.