Bedienungsanleitung - Counters on the ISOBUS job computer

Counters on the ISOBUS job computer

The ISO 11783 standard defines several types of counters that can be transmitted by the ISOBUS job computers to the ISOBUS-TC. The texts of the counters are not the same for all manufacturers and job computers.

The determined values are generally transmitted in decimal units. ISOBUS-TC does not correct anything. This means, for example, that a working time of 0.33 hours corresponds to 20 minutes. Counting always takes place from the start to the end of a task.

Type of counter	Unit	Notes
Total applied quantity.	L, kg, piece
Total yield	L, kg, piece
Applied area	ha, m²
Driven distance in work position	km, m, mm	This is generally the applied distance.
Driven distance not in work position	km, m, mm
Time in work position	Hours, Minutes, Seconds
Time not in work position	Hours, Minutes, Seconds

You can see the counters when you move the ISOBUS-TC application into an additional window of the terminal.

Procedure

To configure the counters:

þ: A task is started.

1.: Tap “Current task”.

2.: Tap “Counters”.

⇨: A list appears with the connected ISOBUS job computers that are involved in the task.

⇨: For each job computer that appears, you can select which counters should be displayed in the additional window. Because not all of the counters fit in the window, make a good selection. Although the counters that were not selected are not displayed in the additional window, they are still documented.