Bedienungsanleitung - List of connections in “Standard“ mode

Operating Instructions

Table of contents

List of connections in “Standard“ mode

Procedure

If you are using the ISOBUS-TC application in “Standard” mode, you can configure the list of connections as follows:

þ: All ISOBUS job computers and virtual job computers that are required for a field are connected.

1.: - Open the ISOBUS-TC application.

2.: Tap “Farm equipment”.

⇨: The “Farm equipment” screen appears.

3.: - Open the list of connections.

⇨: You have called up the list of connections screen.

⇨: A list appears with all of job computers, controllers and ECUs connected to the ISOBUS. The connectors appear between these devices.

4.: Tap the task in the top row in order to select the first implement.

5.: The device that is connected to the ME terminal should appear in the second line. Tap the line with the second implement and select one from this.

6.: You now only need to select the appropriate connector between the two devices. Tap the line between the devices and select the appropriate connector for each device.

7.: - Exit the screen to save the settings.