Bedienungsanleitung - List of connections in “Extended“ mode

Operating Instructions

Table of contents

List of connections in “Extended“ mode

Procedure

If you are using the ISOBUS-TC application in “Extended“ mode, you can configure the list of connections as follows:

þ: All ISOBUS job computers and virtual job computers that are required for a task are connected.

þ: The task is started.

1.: - Open the ISOBUS-TC application.

2.: Tap “Current task“.

⇨: The “Task” screen appears.

3.: Tap “List of connections”.

⇨: You have called up the list of connections screen.

⇨: A list appears with all of job computers, controllers and ECUs connected to the ISOBUS. The connectors appear between these devices.

4.: Tap the task in the top row in order to select the first implement.

5.: The device that is connected to the ME terminal should appear in the second line. Tap the line with the second implement and select one from this.

6.: You now only need to select the appropriate connector between the two devices. Tap the line between two devices and select the appropriate connector for each device.

7.: - Exit the screen to save the settings.