Installation with standard angle bracket
Procedure
Proceed as follows if the standard angle bracket is used without the additional components.
- þ
- There is no GPS receiver on the tractor roof.
- Remove the screws from the tractor roof.
- Position the angle bracket and re-tighten the screws.- 3.
- Make sure that the screws are sealed after tightening.
- 4.
- Center the main bar on the angle brackets. The main bar may not protrude over the edge of the roof. Please note that the connection for the GPS receiver must face the rear.
- 5.
- Attach the main bar firmly with the supplied screws.