Transfer target rates via LH5000
Tested on-board integrated display/controllers*
* - Only on-board integrated display/controllers are listed for which we were able to determine that the serial interface was functional. Results may differ with different software versions.
Procedure
- þ
- You have checked whether you need to activate the LH5000 protocol on the on-board integrated display/controller. If yes, you have activated the protocol.
- Switch on the terminal.
- Open the list of implement profiles.
- Add a new implement profile.- ⇨
- A new implement profile appears on the screen.
- 6.
- Configure the parameters as shown in the following steps.
- 7.
- "Operating Mode" -> "Target Rate Transfer"
- 8.
- "Protocol" -> "LH5000"
- 9.
- "Implement type" -> Select the implement with which you are working.
- 10.
- "Baud rate" -> normally "9600". The baud rate is dependent on the on-board integrated display/controller.
- Activate the implement profile.
- Press and confirm to save the implement profile.Further steps
You have set up the serial interface. You must now configure the applications of the terminal.
In the TRACK-Leader application:
- 1.
- Deactivate the "SECTION-Control" parameter under "Settings / General".
- 2.
- Create an ag equipment profile for the combination of your tractor and mounted implement.
- 3.
- Load a prescription map.
You can load the prescription map in two ways:
- ▪
- As a shp file, in the TRACK-Leader application.
- ▪
- As part of a ISO-XML task, if you are using the ISOBUS-TC application and a FMIS.
For more information, please refer to the TRACK-Leader and ISOBUS-TC operating instructions.