Connecting the terminal to the ISOBUS
In order to be able to operate an ISOBUS job computer with the terminal, you must connect the job computer to the ISOBUS.
You will need a different connection cable for this, depending on the model of your tractor.
- ▪
- In tractors which have been subsequently upgraded with an ISOBUS-basic vehicle harness from Müller-Elektronik, use connector cable A from the ISOBUS-basic vehicle harness.
- ▪
- In tractors which are equipped as standard with ISOBUS and which have an ISOBUS In Cab Connector, you will need the following connector cable:
- –
- D-Sub <-> CPC connector cable, item no. 30322541
- ▪
- In tractors which are fitted with their own ISOBUS terminal, but in which there is however no ISOBUS In Cab Connector, you can ask for the ISOBUS In Cab Connector to be retrofitted.
- –
- You can order the appropriate cable from Müller-Elektronik. Our sales team will be glad to advise you.
- –
- For certain tractors, you can retrofit the connector cable without the ISOBUS In Cab Connector.
- –
- In certain versions, you will also require the D-Sub <-> CPC connector cable, item no. 30322541
When there is more than one terminal in the tractor cab, you may need to change certain settings in order to enable two-way communication. Find out more: Using two terminals
Procedure
- 1.
- Connect the 9-pin plug A of the basic vehicle harness to port A of the terminal.
- 2.
- Tighten the safety screws on the connector.