Company logo
Installation and Operating InstructionsSearchContentsHome
 
Configuring the terminal in the Service applicationConfiguring the "GPS TILT-Module" terrain compensation
 
 
Configuring the "GPS TILT-Module" terrain compensation
 
 
Procedure
 
 
 
þ
The "GPS TILT-Module" terrain compensation is connected.
þ
The tractor is positioned on level ground.
þ
The driver of the external ME LightBar is deactivated.
1.
If any additional devices (e.g. ME LightBar) are connected to the cable between the terminal and the tilt module, disconnect them. The tilt module must be connected directly to the terminal. After the tilt module has been configured, these additional devices must be reconnected.
2.
Measure the distance between the GPS receiver and the ground surface.
3.
Switch on the terminal.
4.
Switch to the tilt module configuration screen:
 Taste Auswahlmenü aufrufen| Service |  Funktionssymbol GPS-Antenne| Tilt module
⇨
The following screen appears:
 
5.
Enter the distance between the GPS receiver and the ground surface in the line "GPS receiver height".
6.
Position the tractor on a ground surface that is known to be level.
7.
Click on the line "Null point calibration".
⇨
The position of the tilt module on level ground is being calibrated.
⇨
After calibration, the angle 0 will appear on the "Angle" line. The displayed angle will change with any tilt of the tractor.
8.
Reconnect all of the additional devices that you had disconnected for the configuration.