Company logo
Installation and Operating InstructionsSearchTable of contentsHome
 
Mounting and configurationConnecting the GPS receiver to a terminal
 
 
Connecting the GPS receiver to a terminal
 
 
NOTICE
Terminal connector supplying power
Potential damage to the terminal from a short-circuit.
1.
Switch the terminal off before plugging in or removing the connector.
 
 
 
Procedure
 
 
 
This is how you connect the DGPS receiver to a terminal:
1.
Switch off the terminal.
2.
Guide the cable of the GPS receiver into the vehicle cab.
3.
Find the appropriate RS232 connection on the terminal. Refer to the operating instructions for the terminal to find out which connection this is. For the majority of terminals from Müller-Elektronik, this is going to be port C.
4.
During initial start-up it can take approx. 30 minutes until the DGPS receiver has reception. At subsequent start-ups it will only take approx. 1-2 minutes.