- By application
- Steering systems and GPS
The TRACK-Guide III, TOUCH800® and TOUCH1200® terminals from Müller-Elektronik comply with the ISOBUS standard 11783 and can be used on all agricultural implements that also comply with this standard, regardless of the manufacturer. The cooperation between Müller-Elektronik and Trimble has now taken the development of this terminal an important step forward: Effective immediately, they are fully compatible with the GNSS receiver NAV-900 and the Trimble® steering system. |
As a result, these ISOBUS terminals also have access to all Trimble correction services, from the basic RangePoint RTX through CenterPoint RTX all the way to the high-accuracy and centimetre-perfect RTK. NAV-900 works with GPS, GLONASS, Galileo and BeiDou satellites. Therefore, it can always determine a precise position, even under difficult conditions. Thanks to xFill technology, users can also work for up to 20 minutes without a correction signal.
The result: Even more efficient operation thanks to higher accuracy, fewer overlaps and lower fuel consumption.
NAV-900 – GNSS receiver and steering job computer
The NAV-900 is Trimble’s most modern GNSS receiver to date, designed to meet the highest requirements in terms of the operating time and offering a large selection of accuracy options, from basic to high-precision. It can be attached to the cab roof on most tractors and other agricultural vehicles and enables determination of the position and parallel guidance, including automatic steering.
EZ-Pilot® Pro, Trimble Autopilot™ Motor Drive und CAN- Autopilot™ – Trimble steering systems
Trimble steering systems use state-of-the-art slope compensation technologies to calculate the actual position of the vehicle and thus ensure high accuracy, even on hilly or uneven terrain. Thanks to the new compatibility, these steering systems can now also be controlled with Müller-Elektronik terminals.
These products are sold through the Vantage specialist network.
Find your regional partner with ourDealer Search at